Actually the way the carpet installers finish those tacks when they do it right is they take the edge of their tucking chisel or the side of a hammer head and rake it across the tacks.
Carpet tacks sticking up through carpet.
This also revealed the installers didn t replace the 30 year old damaged tack strip.
In multiple locations the tack strips are easily poking through the carpet.
When we have to repair these areas we were taught to remove the strip and to directly stick the carpet down using carpet glue a lot safer and lasts longer.
We have z bar metals that the carpet wraps around or it can just be tucked between the tack strip and tile if there is enough height difference as is the case for op.
That s the gripper rods spikes that means either carpet is to thin wrong gripper rods used or glue should have been used.
Entirely up to the customer home owner really.
However it s not so unusual if you press very hard along edges of a carpet to feel the spikes but they shouldn t be sticking right through if that s what.
When i did a carpet installation course we were always told not to install tack strips in walk way areas due to the problems arising such as nails sticking out after the carpet starts to wear.
After the carpet was stretched the installer should have hammered down the pins on the tack strip.
Tear out the soggy pad first go to the corner nearest the wet area grab the carpet with pliers and pull the carpet off the tack strip.
Press down on the carpet firmly without using a hammer so the tacks don t break or bend before they get hold of the carpet.
Run a fan or two to dry the carpet.
The carpet is usually placed over a carpet pad.
The little nails on this exposed tack strip aren t at the 45 degree angle that they should be but are mostly pointing straight up.
Continue pulling the carpet off the tack strip by hand until you can fold back the entire wet section.
The quick fix is to take a hammer and flatten the tacks either with the carpet in place or after peeling back the carpet.
Wet carpet pad is like a big sponge.
You have to get rid of it asap.
Which leads me to my next point pun.
The carpet tack should grip the edges of the carpet through the carpet backing.
However the carpet may stay if the carpet can just barely be tucked against the tile or wood.
I assume this is where carpet transitions to tile or wood.
This curls the sharp points over both locking the tacks onto the carpet and dulling them so that they don t poke your feet through the carpet.
However the tacks will not be holding the carpet in place anymore.